2026 local estimate · updated 2026-07-22
Cost to replace a roof in Atlanta, GA
A typical roof replacement in the Atlanta-Sandy Springs-Roswell, GA area runs $14,024, with most projects landing between $5,208 and $22,840 — about 9% below the national average.
Low
$5,208
Basic materials, simple job
Typical
$14,024
What most people pay
High
$22,840
Premium materials or complex job
What's priced: Full tear-off and replacement on a typical 2,000 sq ft home, asphalt shingles through mid-range materials, installed. Excludes permits, structural repairs found mid-job, and premium upgrades.
Why Atlanta is cheaper than average
Almost entirely labor. Roofers in the Atlanta-Sandy Springs-Roswell, GA area earn about 14% less than the national mean for the same occupation, per Bureau of Labor Statistics wage data. Because roof replacement is roughly 60% labor, that difference flows straight into the total.
Roofing is the most labor-heavy of these projects. Tear-off, disposal, and installation dominate the bill, and asphalt shingles themselves are comparatively cheap — which is why roofing prices vary more between metros than almost any other home project.
Get a number for your own job
The figures above are for a standard project. Your size, materials, and access will move them. Run your own specification through the calculator, then apply the ×0.856 local labor factor to the labor portion.
Open the roof replacement calculator →Permits for a roof replacement in Atlanta
Issuing authority: City of Atlanta Department of City Planning, Office of Buildings (fees codified in Part III Appendix A, Building Code Amendments)
The City of Atlanta Department of City Planning, Office of Buildings exempts non-structural re-roofing repairs that don't touch shingle replacement or truss repairs and that leave no more than three layers of shingles behind — a full tear-off and shingle replacement, which is what a typical roof job involves, falls outside that exemption. The minimum permit fee for re-roofing an existing structure is $360.00, and for miscellaneous permits where a minimum fee is set, a rate of $7.00 per $1,000 of the value of the work is used to determine whether the fee is above the minimum.
If an inspector issues written notice requiring corrected work, each reinspection after the initial inspection adds a $50.00 fee, so getting the roofing work right the first time avoids that extra charge. Confirm with the Office of Buildings whether your specific job — full tear-off versus a partial repair — qualifies for the minimum fee or the per-thousand-dollar rate above it.
When a permit is needed
- “Non-structural re-roofing repairs excluding truss repairs or shingle replacement provided that upon replacement no more than three layers of shingles remain;” — City of Atlanta (via Municode), Atlanta Code §103.4 Work Exempt From Permit (retrieved 2026-09-23)
Fees
- “h. Re-roofing of existing structures—Minimum fee .....$360.00” — City of Atlanta (via Municode), Atlanta Code Part III App. A §104.2 Fees (Municode, current through Aug 25, 2026) (retrieved 2026-09-23)
- “Miscellaneous permits - where a minimum permit fee is set forth, the rate of $7.00 per thousand dollars of the value of work shall be used to determine if the permit fee is to be above the minimum.” — City of Atlanta (via Municode), Atlanta Code §104.2(m) (retrieved 2026-09-23)
Inspections
- “A reinspection fee of $50.00 shall be imposed for each reinspection after the initial inspection when a written notice has been issued requiring the correction of inferior work.” — City of Atlanta (via Municode), Atlanta Code §104.2(c) (retrieved 2026-09-23)
Quoted verbatim; not recalculated.
Nearby metros
- Roof replacement in Provo, UT — typically $14,042
- Roof replacement in Dallas, TX — typically $13,996
- Roof replacement in Birmingham, AL — typically $13,987
Compare roof replacement cost across every US metro we cover — the same labor-adjusted model as this page, ranked from most to least expensive, if you want the national picture rather than Atlanta alone.
How we calculate this
We take a national installed-cost range, split it into labor and materials, and scale only the labor half by this metro's actual wage data. That is the whole model — no black box, and reproducible from the figures on this page.
- National range: $5,700–$25,000, from our roof replacement cost data (last verified 2026-07-13).
- Labor share: 60%. An industry rule of thumb, not a measured value — the softest assumption here, which is why we state it rather than bury it.
- Metro labor factor: ×0.856, being the mean annual wage for Roofers in Atlanta-Sandy Springs-Roswell, GA divided by the national mean for the same occupation.
- Materials: held at the national level. We vary labor by metro and hold materials at the national level. That is deliberate: shingles, copper, HVAC equipment, and cabinets are nationally traded and priced, and what actually varies locally is freight and sales tax — both small next to the labor spread. We have no metro-level materials index we can defend, so rather than invent one, we vary only what we can source.
Wage source: U.S. Bureau of Labor Statistics — Occupational Employment and Wage Statistics (OEWS), metropolitan area estimates, May 2025. A U.S. Government work, in the public domain and free to reuse. Where BLS suppresses wage data for a metro, we publish no page for it rather than fill the gap with an estimate.
Educational estimate only. A real quote for your specific property beats any model, including ours — get at least three.
Related
Frequently asked questions
How much does it cost to replace a roof in Atlanta, GA?+
A typical project in the Atlanta-Sandy Springs-Roswell, GA area runs about $14,024, with most falling between $5,208 and $22,840. Of the typical figure, roughly $7,884 is labor and $6,140 is materials. That puts Atlanta about 9% below the national typical cost of $15,350.
Why is it cheaper to replace a roof in Atlanta, GA than the national average?+
Almost entirely labor. Roofers in the Atlanta-Sandy Springs-Roswell, GA area earn about 14% less than the national average for the same occupation, according to Bureau of Labor Statistics wage data. Because roof replacement is roughly 60% labor, that wage difference flows through to the total. Materials are priced nationally and barely move between metros.
What's included in these Atlanta, GA estimates?+
Installed cost — materials plus labor for a standard project of this type. It does not include permits, which vary by municipality, structural repairs discovered mid-job, or premium upgrades. The range reflects genuine variation in scope and material grade, not uncertainty about the metro. Always get at least three local quotes before budgeting; a real quote for your specific property will beat any estimate, including ours.
How is this different from a national average with the city name swapped in?+
We split the national installed cost into labor and materials, then scale only the labor half using the actual mean wage for Roofers in this specific metro area, published by the Bureau of Labor Statistics. Materials stay at the national level because we have no defensible metro-level materials index — shingles and HVAC equipment are nationally traded, and only freight and sales tax really vary. Where BLS suppresses wage data for a metro, we do not publish a page for it at all rather than fill the gap with a guess.